Without resonance how will you get amplification? Tesla was all about resonance.

From RE_Summary.pdf :

page 3

"If your generator and load are not matched in RF as if they were radio antenna dipole it will not work. They must be
balanced ... is not as simple as taking a frequency source and driving it into a given mass having a load in the middle.
The source will get double the reflected power and burn out as its power factor will be "0", so it has to be properly
matched in resonance to drive the dipole forward to attain end to end resonant energy transmission within an standing
wave in single wire."

And from page 7:

"OU is in resonance of the core !
One way to test is pulsing it with a short pulse & read the way it resonates. There you can find the natural ferroresonance
of your trafo core. Best is to pulse a material into saturation and see wherever there are resonant signals
within the decay pulse signal.
Those FUNDAMENTALS are the basic frequency were OU must be looked into, as is the natural frequency of the
material itself.
Then design COIL and capacitor value to resonate within those CORE sweet frequency ... (hyper Q)
EVERY motor has a sweet point were energy adds to energy ...
If you see Jinis page scope shots you see some spikes, those spikes are the natural resonance harmonics of the
transformer, the resonant slope indicates also its resonant point is on a sub harmonic as spike is very narrowbanded
(compressed in time so Pulse feeding in intermittent pulse-length matched to true fundamental increase its potential ten
fold ( Read Norman Wootan work on MRA ) hyper Q modes.

Resonance is the fundamental base of ZPE energy transformation. OU is transformation."